The PCA9685 16-Channel 12-bit PWM / Servo Driver can drive up to 16 servos over I2C with only 2 pins. The on-board PWM controller will drive all 16 channels simultaneously with no additional Arduino processing overhead. You can chain up to 62 of them to control up to 992 servos.
- GND - This is the power and signal ground pin, must be connected;
- VCC - This is the logic power pin, connect this to the logic level you want to use for the PCA9685 output, should be 3 - 5V max! It's also used for the 10K pullups on SCL/SDA so unless you have your own pullups, have it match the microcontroller's logic level too!
- V+ - This is an optional power pin that will supply distributed power to the servos. If you are not using for servos you can leave disconnected. It is not used at all by the chip. You can also inject power from the 2-pin terminal block at the top of the board. You should provide 5-6VDC if you are using servos. If you have to, you can go higher to 12VDC, but if you mess up and connect VCC to V+ you could damage your board!
- SCL - I2C clock pin, connect to your microcontrollers I2C clock line. Can use 3V or 5V logic, and has a weak pullup to VCC
- SDA - I2C data pin, connect to your microcontrollers I2C data line. Can use 3V or 5V logic, and has a weak pullup to VCC
- OE - Output enable. Can be used to quickly disable all outputs. When this pin is low all pins are enabled. When the pin is high the outputs are disabled. Pulled low by default so it's an optional pin!
- There are 16 output ports. Each port has 3 pins: V+, GND and the PWM output. Each PWM runs completely independently but they must all have the same PWM frequency.
- They're set up for servos but you can use them for LEDs! Max current per pin is 25mA.
- There are 220 ohm resistors in series with all PWM Pins and the output logic is the same asVCC so keep that in mind if using LEDs.
PCA9685 16-Channel 12-bit PWM/Servo Driver I2C
- Производител: TZT
- Код на продукта: 1052
- Наличност: 10
- 5 или повече 7.80 лв.